Eaton 9PX1000IRTANZ-L User Manual

Also see for 9PX: Installation and user manual User guide Advanced user's guide Manual Advanced user's guide

34 Eaton 9PX Lithium-Ion P-164001006—Rev 01Figure 10. Internal Battery Pack Replacement3567214To replace the battery pack:1. Remove the center cover of the front panel.2. Push left cover toward to right direction.3. Open the battery door.4. Disconnect the battery connectors.A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or disconnect it.5. Remove the two screws to pull out the metal protection cover of the battery.6. Pull out the plastic handle of the battery pack, and slide the pack out slowly on to a flat and stable surface.Use two hands to support the battery pack. See "Recycling the used equipment" on page 38 for properdisposal.7. Verify that the replacement batteries have the same rating as the batteries being replaced.8. Put the new battery pack into the UPS. Push the battery pack firmly, reconnect the red and black batteryconnectors then reconnect the BMS communication cable.9. Verify that all of the alarms have cleared on the display.10. Screw back the metal protection cover and the front panel, then clip the center cover.11. If there are no EBM modules that need to be replaced continue to the 6.3 Battery Settings Reset sectionbefore restarting the unit.Replacing the EBM(s)The EBM is heavy. Lifting the cabinet into a rack requires a minimum of two people.To replace the EBM(s):Replacing Batteries