Eaton 9PX8KSP Installation And User Manual

Also see for 9PX10KSP: Installation and user manual

Page 25614-00205-01_ENENGLISH6.3 Display functionsPress the Enter ( ) button to activate the menu options. Use the two middle buttons ( and ) to scrollthrough the menu structure. Press the Enter ( ) button to select an option. Press the button to cancelor return to the previous menu.Main menu Submenu Display information or Menu functionMeasurements [Total Load] W VA A PF / [Load phase 1 (N-L1)] W VA A PF /[Load phase 2 (N-L2)] W VA A PF] / [Input/Bypass] V- L1 V- L2 Hz/ [Total Output (L1-L2)] V Hz (N-L1)V (N-L2)V / [Efficiency] % /[Battery] % min V1 V2 / [DC bus] V / [Average power usage] Wh /[Cumulat. power usage] kWh since dateControl Go to Bypass /Go back normalTransfers the UPS on Bypass mode /Transfers the UPS on Line modeStart battery test Starts a manual battery testReset fault state Clears active faultRestore factory set Returns all settings to original valuesReset average power Clears average power usage measurementReset cumul. power Clears cumulated power usage measurementDry contacts test Tests dry contact relay outputsSettings Local settings Sets product general parametersIn/Out settings Sets Output parametersOn/Off settings Sets On/Off conditionsBattery settings Sets battery configurationEvent log Event filter Selects faults, alarms and/or events to displayEvent list Displays the events storedReset event list Clears eventsFault log Fault list Displays the faults storedReset fault list Clears faultsIdentification [Product type/model] / [Part/Serial number] / [UPS/NMCfirmware] / [Com card IPv4], [Com card IPv6], [Com card MAC] /[Detected accessories]Register product Links to Eaton registration website6.4 User settingsThe following table displays the options that can be changed by the user.Submenu Available settings Default settingsLocal settingsLanguage [English] [Français] [Español][Português]Menus, status, notices and alarms,UPS fault, Event Log data andsettings are in all supportedlanguages.[English]User selectable when UPS ispowered for the first time.Date/ time Format:[International] [US][US]LCD Modify LCD screen brightness andcontrast to be adapted to room lightconditions.Audible alarm [Enabled] [Disabled on battery] [Alwaysdisabled]Enable or disable the buzzerif an alarm occurs.[Enabled]In/Out settingsOutput voltage [100V] [110V] [115V] [120V] [127V]Can be changed only in Standby mode.[120V]Output frequency Frequency converter:[Enabled] [Disabled]Frequency settable in frequencyconverter mode.[Disabled]Output mode [Industrial] [Network]Set UPS behavior regarding transferon Bypass.[Network]Input volt hysteresis Sets input voltage hysteresisfrom 1 to 10V.[10V]High Efficiencymode[Enabled] [Disabled]Power the output from Bypassfor high efficiency.[Disabled]6. HMI and settings