Eaton A200 Instruction Leaflet

Also see for A200: Instructions Instruction leaflet Instruction leaflet Instruction leaflet

Instruction Leaflet IL16958 Effective May 2011Supersedes August 1992A200 Size 00, 0, 1 3 Pole Motor ControllerTHE CONTROLLERThe A200 motor controller, when wired as shown in Figure6 or 7, will operate as a full voltage starter and will giveprotection against overload, but not against short circuitcurrents, when wired and provided with overload relay (OlR)heaters as listed in heater selection tables or when usedwith any means of inherent protection activated by motortemperature.The controller should be protected against short circuits byproviding branch circuit protection not to exceed the maximumprotective device ratings listed in Table II.This industrial type control is designed to be installed, perated,and maintained by adequately trained work-men. Theseinstructions do not cover all details, variations, or combinationsof the equipment, its storage, delivery, installation, check out,safe operation, or maintenance. Care must be exercised tocomply with local, state, and national regulations, as well assafety practices, for this class of equipment.AUXILIARY CONTACTS - TYPE JOne normally-open pole adjacent to the power poles issupplied as the holding circuit auxiliary. A maximum of fourType J auxiliary units can be installed in the recesses ofeach contactor. These may be mounted with the terminalsin line with the power poles or may be mounted with theterminals in a right angle relationship to the power poles.Auxiliary contacts mount by means of a spring clip andretainer screw.Figure 1. Size 1 A 200 ControllerFigure 2. Dimension Drawings (Dim. in inches)