Eaton S701 Instruction Leaflet

Pub 49440Effective 01/02 1Instruction Leaflet for S701 Soft StartersDescriptionThe S701 device is a reduced voltage soft start series control-ler designed to control acceleration and deceleration of three-phase motors. The S701 provides the user the ability to adjustinitial torque, ramp up and down time, and also select kick startfor high inertia loads.ApprovalsCAN. CSA-C22.2 / UL Std. No. 508IEC 947-4-2, IEC 158-2,EN 60947-4-2, HD 419.2-S1CE MarkedMounting GuidelinesImportant — The S701_15, and S701_25 controllers aredesigned for vertical mounting in free air. If these controllersare mounted horizontally, the load current must be reduced to50% of rated current.WARNINGDO NOT INSTALL OR PERFORM MAINTENANCE ON THISDEVICE WHILE EQUIPMENT IS ENERGIZED. DEATH ORSEVERE PERSONAL INJURY CAN RESULT FROM CON-TACT WITH ENERGIZED EQUIPMENT. VERIFY THAT NOVOLTAGE IS PRESENT BEFORE PROCEEDING WITHINSTALLATION OR MAINTENANCE.Only qualified persons, as defined in the National ElectricCode, who are familiar with the installation, maintenance andoperation of this device and the equipment onto which it is tobe installed, as well as applicable local, state and national reg-ulations and industry standards and accepted practicesregarding safety of personnel and the equipment safety shouldbe permitted to install, maintain or operate this device. Theseinstructions are provided only as a general guide to such quali-fied persons and are not all-inclusive. They do not cover everyapplication or circumstance which may arise in the installation,maintenance or operation of this equipment. Users are advisedto comply with all local, state and national regulations andindustry standards and accepted practices regarding safety ofpersonnel and equipment.CAUTIONREMOVE ALL POWER FROM THE INSTALLATIONBEFORE ATTEMPTING TO INSTALL OR REMOVE THISDEVICE. THIS INCLUDES L1, L2, L3 AS WELL AS A1, A2,11 AND 12.Dimensions, mm [inches]Figure 1. Approx. Dimensions in mm [inches] — S701_03Figure 2. Approx. Dimensions in mm [inches] — S701_15Figure 3. Approx. Dimensions in mm [inches] — S701_25Figure 4. Approx. Dimensions in mm [inches] — Mounting84,0 [3.31]100,7 [3.96]127,3 [5.01]90,0 [3.54]120 [4.72]123,8 [4.87]3,5 [0.14]22,5 [0.89]8,5 [0.33]100 [3.94]109 [4.29]4,5[10.0]45,01.77110,0[4.33 ]45,0[1.77]110,0[4.33 ]4,3[0.17 ]120[4.72 ]3,8[0.15 ]8,5[0.33] 128,1[5.04 ]110,0[4.33 ]4,5[0.10]30[1.18]90 [3.54]100 [3.94]30[1.18]8,5 [0.33] 128 [5.04]120 [4.72]4,3 [0.17] 3,8[0.15]110 [4.33]94 [3.70]S701_15 & S701_25Requires 50%rating reduction forhorizontal mounting80 [3.15]30,0 [1.2]30,0 [1.2]S701_03Can be mountedin any position