Web Interface OperationEaton Advanced ePDU User’s Guide P-164000042—Rev 1 www.eaton.com/ePDU 793. In the General Access panel, perform the following:l Type the superuser login.l Type the superuser password.l Type the superuser password again.4. Click Save.Configure Multi-Users1. Access the Web interface and log in.2. Open the Access Control page.3. In the Multi User Access panel, perform the following:l Select the user to configure from the combo box.l Type the user’s login.l Type the user’s password.l Type the user’s password again.4. Choose one of the following security levels:l No Access: The user is not allowed to access the Web interface.l Read-Only: The user can access the Web interface, but is not allowed to change any settings orperform actions.l Read/Write: The user can access the Web interface and is allowed to change settings and performactions.5. Click Save.Configure the DNSWhen the IPv4 address is automatically obtained by DHCP, the DNS server addresses (primary and secondary)are provided by the DHCP server.Nevertheless, you can define DNS IPv4/IPv6 addresses from the Web and Serial interfaces. However, thisconfiguration is overwritten when the Network Management Card restarts and the IPv4 address is obtainedfrom a DHCP server that provides DNS addresses.1. Access the Web interface and log in.2. Open the SMTP & DNS page.3. Type the primary DNS server’s IPv4 or IPv6 address.4. Type the secondary DNS server’s IPv4 or IPv6 address (if any).5. Click Save.Enable/Disable SSL EncryptionBy default, SSL encryption is disabled.1. Access the Web interface and log in.2. Open the Access Control page.3. Ensure that the HTTP Enabled check box is checked.4. Check the Force SSL check box to enable SSL encryption, or uncheck the box to disable it.
