Eaton Bussmann Series Installation Manual

Also see for Bussmann Series: Installation manual Installation manual Instruction sheet Installation manual Installation manual

7Installation manual 3A3718 RevEEffective February 2019CCP2-H4X-_ pistol handles for 12 mm shaftsEaton.com/bussmannseriesRight side clockwise handleoperation and installationThe following applies to all clockwiseoperating handles.Procedures for clockwise handlecatalog numbers:• CCP2-H4X-B3 (short)• CCP2-H4X-R3 (short)• CCP2-H4X-B4 (long)• CCP2-H4X-R4 (long)For installation with switch catalognumbers:• CCP2-(poles)-200CF• CCD2-3-200• CCP2-(poles)-400CF• CCD2-3-400And requires installation of:• The side rotary mechanism:• CCP2-SM mounted on the switch’sright side• Either shaft catalog numbers:• CCP2-SH2-225• CCP2-SH2-425OFFONOFFSwitch operating modesNOTE: Side installation(handle mounted on theenclosure’s side and notthe door) does NOT providefor an interlock means toprevent opening the doorwhile the switch is in eitherthe ON or OFF position.If preventing access tothe enclosure’s interior isdesired or required by theapplication, use a lockingdoor latch or install a suitablehasp to accept a lock.Handle lock ON operationNote: NOT to be utilized when switch is applied as a means for emergency stop.ONOFFXXON ON ONOFF OFFOFFX2.5 mm Allen wrench3 N•m (27 lb-in)Break out thisportion ofthe bezel2.5 mm Allen wrenchTo enable the handle’s lock ON feature:• Use a 2.5 mm Allen wrench to loosen the setscrew and remove the handle from the handlebase as shown.• Using needle nose pliers, break off the retaining stop on the switch handle bezel as shown.• Place handle back onto the handle base and tighten the setscrew to 3 N•m (27 lb-in).