Eaton CROUSE-HINDS SERIES Operating Instructions Manual

Also see for Crouse-hinds series: Operating instructions Instruction manual Operating instructions Operating instructions Instruction manual

Contents

Eaton CROUSE-HINDS SERIES Operating Instructions Manual Manual pdf 13 page image

139. Disposal / RecyclingWhen the apparatus is disposed of, the respective national regulations onwaste disposal will have to be observed.In order to facilitate the recycling of individual components, plastic partsare provided with the identification mark of the plastic material used.In case of disposal you can obtain additional information from your CooperCrouse-Hinds / EATON branch.Subject to modifications or supplement of the product range.8.1 LED-module replacementLED-module replacement can be done without cut off the luminairefrom mains supply, because an all pole switch will isolate thelampholders while opening the protective bowl.Notice: Observe national standards or directions for use which can bedivergent to this!The LED-module have to be replaced as shown in fig. 11 and 12.OperationLED Modul 400/800MainsLED Modul 400/800Mains / EmergencyAchtung! Chemische Beständigkeit beachten.Nur mit feuchtem Tuch säubern.Warning! Do not use chemical cleaner.Clean with a damp cloth only.Important! Attention à la resistance chimique.Nettoyer uniquement avec unchiffon humide.BatteryMains or okor okVE 12 faultyVE 12 faultyEmergency okV Battery low, Lamp faultv Battery faultMains OFF v LED red -green ONMains ON , LED red, -green flashingLED row of module OFF V V LED red, -green OFFLED row of module ONFault indicator: eLL. .. NE;(Test during continuous switching of light fitting - combinations with several faults are not registered)See the enclosed operating instructions for eBK12, No. 3 2211 00 172, for further information on the function and fault indication.Explosion protected emergency light fittingsSeries: eLLK(M)(S)92 LED 400A(800A) NE GB