Eaton ESF-E30 Series Mounting And Operating Instructions

Contents

31 Important NotesMANUAL ESF-E30 40071860041 (G) November 2018 www.ceag.de1 Important Notes1.1 General InformationMounting work may only be performed by skilled electricalpersonnel (see DIN VDE 0105 part 1, the German AccidentPrevention Regulation BGV A2 of the Association ofCommercial and Industrial Workers’ Compensation Insu-rance Carriers, or analogous regulations and guidelines inthe country where the equipment is to be installed andoperated). Other persons may only perform the activitiesdescribed in these instructions if– they have received proper and professional instruction,– their tasks and activities have been precisely definedand understood,– the activities are performed under the oversight andsupervision of experienced and expert personnel.When working with these mounting and installationinstructions, special attention must be paid to the notesmarked with symbols and key words as follows.1.2 Description of SymbolsIn these operating instructions, important safety-relatednotes are labelled with symbols.NOTE:Provides important tips and advice on the procedures tobe followed or on the handling of the device or compo-nents described.ATTENTION!Draws attention to possible sources of danger that mightcause damage to equipment or components, as well as tothe environment.WARNING!Draws attention to possible sources of danger that mightcause personal injury or severe damageto equipment or components, as well as to the environ-ment.DANGER!Draws attention to possible sources of danger that mightcause life-threatening personal injury orextreme damage that indirectly endangers people or theenvironment.WARNING!The depictions in these mounting and installation instruc-tions only serve, to some extent, as illustrations of thecontent matter. Wherever• dimensionally accurate work or• precise drawings adapted to on-site characteristics arerequired,it is mandatory to comply with the drawings that havebeen specially created for the equipment.WARNING!Only perform work for which you possess sufficienttechnical qualifications and for which you have receivedinstruction regarding the on-site operating conditions!Extensions, modifications, repairs and other routine worknot described in these instructions are to be reserved forspecially trained specialist and service personnel (from themanufacturer CEAG or from vendors and service providersauthorised by CEAG)!1.3 Information regarding the Mounting andInstallation InstructionsPlease keep these mounting and installation instructionssafe, as they form an integral part of the delivered firesafety enclosure. Safe and approved functioning can onlybe assured by observing these instructions.1.4 Further Applicable DocumentsIn addition to these mounting and installation instructions,the mounting and operating instructions for the centralbattery system ZB-S must also be observed.1.5 Liability and GuaranteeAll indications and notes in these mounting and installationinstructions were compiled taking account ofthe regulations in effect, the state of the art, and our long-standing knowledge and experience. The mounting andinstallation instructions must be stored in the immediatevicinity of the device and must be available at all timesto all persons who work on or with the device. Thesemounting and installation instructions must be read care-fully before the start of all work performed on or with thedevice!1.6 Copyright ProtectionThe mounting and installation instructions are to behandled confidentially. They are exclusively for the use ofpersons engaged in work on and with the device. All indi-cations, texts, drawings, images and other representationscontained in the instructions are protected by copyrightlaw.1.7 Spare PartsOnly use original spare parts from the manufacturer.Incorrect or faulty spare parts can cause damage, malfunc-tioning or the complete failure of the device.WARNING!The use of unapproved spare parts causes all guarantee,service, damage and liability claims to be forfeited.1.8 DisposalIf no return or disposal agreement has been reached,disassembled components are to be conveyed to be recy-cled after appropriate dismounting.