Eaton HALO WP2547LH Instruction Manual

Questions?/Des questions?/¿Preguntas? 1-800-334-6871 ConsumerProducts@eaton.com1Instruction Manual/Manuel d’instructions/InstruccionesPACKAGING CONTENTS/CONTENU DE L’EMBALLAGE/CONTENIDO DEL PAQUETEMOUNTING AND WIRING YOUR FIXTUREWARNING: Risk of electric shock. Disconnectpower at fuse or circuit breaker before installingor servicing.NOTE: The back plate has a cast-in drill and knock-out template to match any standardrecessed junction box, three 5/16” knock-outs for mounting holes (A) and three 1/2” NPStapped holes (D) for surface conduit or photocontrol unit (see Fig. 1).A - 5/16” diameter knockouts (back side)B - 9/16” diameter knockout (back side)C - knockouts for #10 screw (inside)D - 1/2” NPS tapped holes (top and side)1. Open the fixture by loosening the two screws onthe side and remove the lens assembly (A). Removethe LED module from the back plate (B) to clear themounting space.2. Prepare the back plate for mounting by drilling orknocking out the appropriate holes. (See Fig. 1 ).3. Line up the back plate in the desired location andmount securely4. Caulk all holes in the back plate (mounting holes,conduit holes, plugs). Caulk around back plate whereit contacts the mounting surface to provide a water-tight seal.ITEMS REQUIRED(Purchase separately)• Phillips screwdriver• Hex bit driver• Outdoor weatherproof silicone caulkingIMPORTANT SAFETY INSTRUCTIONSWhen using product, basic precautions should always be followed, including the following:• Heed all warnings, including below warnings AND those included on product.• Save these instructions and warnings.• cULus LISTED for outdoor, wet location• Read and follow these instructions.• Risk of fire/electric shock. If not qualified, consult an electrician.• Disconnect power at fuse or circuit breaker before installing or servicing.CAUTION• Connect fixture to a 120-277 volt, 50-60 Hz power source. Any other connection voidsthe warranty.• Fixture should be installed by persons with experience in household wiring or by aqualified electrician. The electrical system, and the method of electrically connectingthe fixture to it, must be in accordance with the National Electrical Code and localbuilding codes.• Fixture designed for wall mount above 4 ft. only. Mount fixture to a grounded standardjunction box marked for use in wet locations.• This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may causeundesired operation.WARNING: FCC Regulations state that any unauthorized changes ormodifications to this equipment not expressly approved by the manufacturercould void the user’s authorization to operate this equipment.SAVE THESE INSTRUCTIONS.WP2547LHA. Lens AssemblyAssemblage de la lentilleMontaje de la lenteENGLISHC. (1) Safety Torx T-20 Driver Bit(1) mèche d’entraînement Safety Torx T-20(1) broca de seguridad Torx T-20WARNINGB. Back Plate (Preinstalled to housing)Plaque dorsale (préinstallé sur le boîtier)Placa trasera (preinstalada en el alojamiento)1CA DADDCBA

/ 4

Related manuals for Eaton HALO WP2547LH