Eaton LumaWatt Installation Instructions Manual

INS #Brand Logoreversed out ofblackINS #IB512003ENInstallation Instructions - LumaWatt Remote SensorInstructions d’installation - Capteur de télédétection LumaWattInstrucciones de instalación - Sensor remoto LumaWattIMPORTANT: Read carefully before installing fixture. Retain for future reference.GENERAL: Upon receipt of the fixture, thoroughly inspect for any freight damage which should be brought to theattention of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on thehousing to assure you have received the correct material.SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes andordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure underinstallation section.APPLICATIONS: The remote sensor housing incorporates a LumaWatt wireless sensor available with three alternatecontrol options:OPTION 1: Control Relay only (CR) provides 0-10V dimming capable of controlling a maximum of five dimming drivers(2mA per driver), ON/OFF relay switching of a 3-amp load@120v (600W) as well as power monitoring and all the fullbenefits of LumaWatt management.OPTION 2: A Switching Relay (SR) is added to the control relay to service an 8-amp to 16-amp load (depending onvoltage). Power monitoring is not available for this option. Dimming control not available.OPTION 3: The remote sensor housing can also be used as a repeater or “hopper” in which case neither of the relaysoptions need to be connected. Line in power will only need to be connected for the sensor to operate.WARNINGMake certain power is OFF before starting installationor attempting any maintenance.WARNINGRisk of fire/electric shock. If not qualified, consult anelectrician.WARNINGRisk of Electric Shock – Disconnect power at fuse orcircuit breaker before installing or servicing.WARNINGRisk of Personal Injury – Fixture may become damagedand/or unstable if not installed properly.●● Do not mount luminaire within 6” of a combustiblesurface.NOTE: These instructions do not claim to cover all detailsor variations in the equipment, procedure, or processdescribed, nor to provide directions for meeting everypossible contingency during installation, operation ormaintenance. When additional information is desiredto satisfy a problem not covered sufficiently for user’spurpose, please contact your nearest representative.NOTE: This fixture has been shipped complete with oneof several mounting options. Please follow the installationinstructions specific to the catalog part that you ordered.NOTE: Care must be taken not to set fixture down onoptical lenses or lift the fixture in the lens area.NOTE: Specifications and dimensions subject to changewithout notice.