Eaton LumaWatt Installation Instructions Manual

2EATON IB512003EN Installation instructionsInstallation Instructions - LumaWatt Remote SensorINSTALLATIONThis lighting fixture has been shipped complete with oneof several mounting options. Please follow the installationinstructions specific to the catalog part that you ordered.Tools requiredRatchet, a shallow 3/4” socket and 1/4 hex nut driver; 3/8”Allen drive for 1/2” inch bolt; #2 Phillips head screw driver;torque wrench.Pole Mount (Figure 1.)The housing mounts standard to a square pole using thetoggle bolts supplied. A round Pole mount adapter (included)mounts housing to a 4”- 6” round pole. A 4” pole is theminimum recommended.1. Mount toggle bolts to pole by inserting the toggle intothe pole. If using a round pole mount adapter (optional)shown, install toggle through the 1/2” holes first.Cinch up collar against pole and remove finger tabs.Squeezing the tabs will shear them at the cinch collar.(Figure 2.)2. Fasten housing mounting plate, slot facing downward,with 2 x ¼”-20 hex bolts as shown. Tightening torqueshall be 50 in-lbs. (Figure 3.)3. Route and attach wires per wiring diagram. Feed wiresthrough the mount plate and feed wires through thepole.ote:N 3’ of leads are provided extending outside thehousing. (Figure 4.)4. Insert wires into the pole as you place the housing onthe mount plate. The bracket on the inside fixture andlanyard allow for hanging the housing during installation.ote:N Do not to pinch the lanyard cable when installingthe housing. Once the housing is in position, tightenusing (2) set screws. Tighten until screw is bottomedout.Figure 1.Figure 2.Figure 3.5. Verification. Once powered a LED indicator under thesensor lens will glow continuous green, indicatingthat the sensor is ready for commissioning. See theLumaWatt Admistrators Guide or Lumawatt installationsheet for troubleshooting information.Square PoleMountRound PoleMount30” [760mm]Maximum1-1/2” [38mm]Diameter Hole(2) 1/2” [13mm]Diameter Holes4-9/16”[117mm]2-1/2” [64mm]2-1/16” [53mm]After TabsBroken FlushFingertabsAligned Topand BottomShown withTabs BeforeBreaking Off.Collar SideFlushUP1/4-20 X 1.5”Hex BoltWall Plate withGasket InstalledSlot Facing DownFigure 4.HousingMountingScrewsLanyardHook TabLanyardHook TabHousingMountingScrews