Eaton Lumark Axcent Installation Instructions Manual

2EATON IB514031EN Installation instructionsInstallation Instructions – Axcent (Small & Large)INSTALLATIONThis lighting fixture has been shipped complete with oneof several mounting options. Please follow the installationinstructions specific to the catalog part that you ordered.otee:N Care must be taken not to set lighting fixture downon optical lenses or lift the fixture in the lens area.Wall MountTools Required#2 Phillips head screwdriver, torque wrench.1. Remove the wedge plate by loosening the (2) ¼-20Phillips head screws on the fixture. (Figure 1.)2. Attach the wedge plate to the wall or junction box(Figure 2). Wedge plate must be mounted withhardware able to support a fixture weight of up to 25 lbs.otee:N The fixture is fully sealed and does not require anyadditional water proofing.Figure 1.Figure 2.Figure 3.WallWallJunction Box Mounting(Recommended Wet Location TypeJ-Box supplied by others)J-Box Recessed in WallJ-Box Mounted on Wall(2X) Phillips head¼-20 Lock ScrewsLevel BubbleLevel BubbleWedge PlateWedge PlateWedgePlate5 1/4” Axcent Large3” Axcent Small3. Hang the fixture from the wedge plate using the wirehanger located on the back of the fixture (Figure 4).Wire hanger can be located by looking for the red flaglabel.4. Make wiring connections per wiring diagram. (Figure 3.)otee:N Dimming wires will not exit fixture when fixtureis ordered with motion control device. If externaldimming control is not used then cap off gray andpurple wires.5. Lift the fixture off of the wire hanger and onto wedgeplate. Ensure that the luminaire supply leads are notpinched between the wedge plate and the housing.6. Tighten the two ¼-20 Phillips head screws on thefixture to 20 in-lbs. (Figure 5.)3.0”FixtureBlackWhiteGreenGrayPurple(+) Line(-) CommonGroundDimming Control0-10V