Eaton MENVIER30 Installation Manual

Also see for MENVIER30: Quick user guide

Menvier30 InstallationPage 1912 seconds after the lastkeypress. The action ofthe backlight depends onthe programming of thecontrol unit (which musthave Release 3 softwareor higher installed).4. Leave local programmingmode and save yourchanges (see below).To Disable/Enable the Status OK LED1. Enter Local Programmingmode.MENUABCD 2. Press  repeatedly untilthe display shows:MENUSTATUS OK LED 3. Press  repeatedly toselect one of thefollowing:Status OK LED ON (). MENUSTATUS OK LED Status OK LED OFF ().The green status LEDunder the navigation keywill glow for 20 secondsafter the last press (thismay be useful when thekeypad is placed inbedrooms that should becompletely dark at night).MENUSTATUS OK LED 4. Leave local programmingmode and save yourchanges.To Disable/Enable the Status FaultLED1. Enter Local Programmingmode.MENUABCD 2. Press  repeatedly untilthe display shows:MENUSTATUS FLT LED 3. Press  repeatedly toselect one of thefollowing:Status Fault LED ON (). MENUSTATUS FLT LED Status Fault LED OFF().The red Fault LED underthe navigation key isdisabled, and will notglow for any fault reports.MENUSTATUS FLT LED 4. Leave local programmingmode and save yourchanges (see below).To Leave Local Programming Modeand Save ChangesEITHER:Press ORClose the keypad tamper.The keypad saves the changes you have made inits local memory.You can now remove 12Vdc power, if required, orleave Installer Menu on the control unit.KEY-EP External Prox ReaderFigure 29 shows the outside details of the externalprox reader KEY-EP:1. LED window.2. Retaining Screw.3. Removable Fixing Plate.4. Permanently attached cable.Figure 29 External Prox Reader KEY-EPSiting the External Prox ReaderDo site the External Prox Reader:At a convenient height and location for the user.Note that the external prox reader is fitted with alength of 2m of the appropriate cable. The cablecan be extended up to 50m by connecting anadditional length of 7/0.2 un-screened alarmcable.Do NOT site the External Prox Reader:Next to electronic equipment, particularlycomputers, photocopiers or other radioequipment, CAT 5 data lines or industrial mainsequipment.Note: Do not site the external prox reader closerthan one meter to any other kind of prox reader(for example an i-kp01, KEY-KPZ01/KP01 oranother external prox reader). If you do so thenthe prox readers will interfere and be unable toread tags.2341