Eaton PORTFOLIO LSR2B Installation Instructions Manual

2EATON IB520031EN Installation InstructionsInstallation Instructions - LSR2B / LSSQ2B Commercial LED Rough-InINSTALLATIONSurface Mount Installation1. Install cylinder mount plate to junction box(see figure 1).a. The plate has a 45-degree adjustment (applicable forSquare Cylinders).2. Install “canopy” using screws provided to the mountplate (see figure 2).3. Hook cylinder tether to the junction box or the mountplate.4. Wire unit per wiring diagram (see electrical section).When complete, push wires into junction box.5. Position cylinder underneath mount plate hooks/snaps.Lift into place and twist until locked (see figure 3).6. Insert trim into the opening of the LED module until itis flush against the cylinder (for round cylinders) or flushagainst the square trim plate (for square cylinders).7. For wet location, covered ceiling applications, applycaulk between the canopy and the cylinder as well asthe ceiling and the canopy.Attach “Canopy”To Mount Plate45-Degree Slot ForRotational AdjustmentFigure 1.Figure 2.Figure 3.Bring Cylinder CloseTo Ceiling And TwistClockwiseAttach Tether ToMount Plate OrJunction BoxTwist Until LockedMechanism Shown WithoutCylinder For ClarityFit Hooks ThroughThis OpeningMount Plate SnapHooksMechanism Shown In LockedPosition Without CylinderBody For ClarityCylinder Has Been RotatedInto Locked PositionCylinder Mount Plate