Eaton Pauluhn Meridian FDA Series Installation & Maintenance Information

IF 1898 • 04/22 Copyright © 2022, Eaton’s Crouse-Hinds Division Page 1Pauluhn™ LED LuminairesMeridian FDA Series: White and RV-1(Combo) Emergency Luminaire, Inside Drip-proof TypeInstallation & Maintenance InformationSAVE THESE INSTRUCTIONS FOR FUTURE REFERENCEIF 1898IMPORTANTEmergency lighting system should be installed, inspected, operated andmaintained by qualified and competent personnel.WARNINGTo avoid personal injury or equipment failure,Equipment should be mounted in locations and at heights where it will notreadily be subjected to tampering by unauthorized personnel.Do not mount near heat-producing equipment.!WARNINGTo avoid personal injury, fire, shock and/or equipment failure,Do not use this equipment for other than intended use.Make sure the supply voltage is the same as the equipment voltage.Do not operate in ambient temperatures above those indicated on theequipment nameplate.Use proper supply wiring as specified on the equipment nameplate.Electrical power must be turned OFF before and during installation andmaintenance. Keep tightly closed when in operation.Install only wiring systems with an equipment grounding conductor (whichmay be the conduit system).Do not use accessory equipment not recommended by the manufacturer.All gasket seals must be clean and undamaged.Use only replacement parts from Eaton’s Crouse-Hinds Division.!1. Read carefully before installing and wiring luminaire and retain for futurereference.2. Check the label rating to ensure the luminaire is suitable for the environmentand supply.3. The luminaire should be installed in accordance with the National ElectricalCode and any codes having jurisdiction over the installation area.4. Disconnect the luminaire from the supply circuit before opening. Keep tightlyclosed when in operation.5. See product label for minimum supply wire temperature rating.6. All luminaires must be properly grounded.7. See product label for maximum ambient temperature.8. Under NO circumstances should the internal reflector be opened or removedduring operation.9. All wiring should be done by qualified electricians only!10. Do not attempt to make electrical connections with the power ON. Seeproduct label for input and amperage load per luminaire.11. Do not mount near gas or electric heaters.12. Do not use this emergency driver for other than intended use.13. Battery is rechargeable LiFePO4 type and must be recycled or disposed ofproperly.14. Do not attempt to touch LEDs.15. AC power must be off before proceeding with assembly, installation orservicing of emergency driver.16. The emergency battery requires a minimum charge time of one (1) hourbefore testing the circuit. A minimum of twelve (12) hours is required for a fullcharge.17. BATTERY DISABLE PROCEDURE: Unit must be powered within 6 months.To ship a luminaire with the battery connected without draining the batterythe procedure is: a. Driver is installed in a luminaire. b. Battery is switched tothe “ON” position. c. Luminaire is powered and tested. d. Luminaire is un-powered; the unit enters Emergency mode. e. Battery is switched to “OFF”,wait about 3 seconds then switch the battery back to the “ON” position.18. Not recommended for installations where unit will be without power formore than 6 months.856.533.72655.925.8263324.92323.912.751054.131877.36856.533.72655.925.8263324.92323.912.751054.131877.36When using electrical equipment, basic safety precautions should always befollowed, including the following:1. Replace entire battery and driver unit when necessary. Contact themanufacturer for information on service.2. Do not attempt to service battery.IMPORTANT SAFEGUARDS – READ AND FOLLOW ALL SAFETY INSTRUCTIONSSAVE THESE INSTRUCTIONS

/ 5

Related manuals for Eaton Pauluhn Meridian FDA Series