Eaton Portfolio LDSQA4 Installation Instructions Manual

INS #Brand Logoreversed out ofblackINS #WARNINGDo not energize the LED Engine until the protectivecover has been removed with the optic and lower trimproperly installed. Do not touch the surface of the LEDas it may damage the light engine.otee:N This fixture should be supported by main runners orother structure that is capable of supporting fixtureweight of 35 Ibs.SAFETYe: When using electrical equipment, basic safetyprecautions should always be followed, including thefollowing:1. This unit is for recessed mounting only. Do not use inhazardous locations nor near gas or electric heaters.2. Do not use this equipment for other than the intendeduse.3. Install only in accordance with National Electrical Codeand local regulatory agencies’ requirements.IMPORTANTe: Read carefully before installing fixture.Retain for future reference.WARNINGRisk of Electrical Shock! Disconnect power at fuse orcircuit breaker before installing or servicing.WARNINGRisk of Fire! For Non-IC fixtures do not installinsulation within 3 inches (76 mm) of any part of theluminaire fixture or in a way that may entrap heat.WARNINGInstallation and servicing to be performed only byqualified personnel. If not qualified, consult anelectrician.Installation Instructions - LDSQA4 Commercial RecessedAdjustable LEDInstructions d’installation - Lampe commerciale réglable encastrée àDEL LDSQA4Instrucciones de instalación - del LED ajustable comercialempotrado LDSQA4Aperture CeilingCutoutFixtureHeight Lumens Ceiling TypeLDSQA4 5-1/4”x5-1/4”5-1/8”x5-1/8” 9"900-1800 IC or Non-IC2800 Non-ICFigure 1.IL520003EN