COMMUNICATIONPower Xpert 9395 Plus 1 UPS (225–275 kVA) Installation and Operation Manual 164201710 Rev 7 www.eaton.com/powerquality 8-38.3 Power Management SoftwareEaton’s Intelligent Power® Software solution, based on Web2.0 technology, includestwo applications: Intelligent Power® Manager™ for UPS management andmonitoring, and Intelligent Power® Protector™, which allows graceful shutdown ofoperating systems.Eaton’s Intelligent Power® Software gives you all the tools you need to monitor andmanage power devices on your network, even in a virtualised environment. Thisinnovative software solution combines the most critical applications in ensuringsystem uptime and data integrity: not only power monitoring and management, butalso graceful shutdown during an extended power outage.Because it can manage redundant power systems, it is an ideal solution for the mostcritical IT environments with stringent requirements for power availability andreliability. Yet it is easy to use – the software scales flexibly from a simplesinglecomputer, singleUPS configuration, to the most sophisticated highavailabilityenvironments.”The software’s mass configuration capabilities make installation and maintenanceeasy, which minimizes the effort required and benefits the bottom line. Eaton’scosteffective Intelligent Power Software manages up to ten devices at no charge,with licences for up to 100 devices – or even an unlimited number – also available.Contact your Eaton Sales representative for additional information.8.4 Building Alarm MonitoringThis standard feature lets you connect the UPS to your building alarms, such assmoke detectors or overtemperature alarms. The customer interface terminals forexternal connections are located inside the UPS. You should use twisted-pair wiresfor each alarm input and common.The building alarms can be programmed to display the alarm functional name.8.5 General Purpose Relay ContactOne general purpose relay contact is provided as a standard feature on the UPS. Thealarm contact is located inside the UPS on the customer interface terminal board.You can use a normally-closed or normally-open contact. If the state of the contactchanges from the state you specify as normal, a signal is issued. You can connect thiscontact to equipment at your facility (such as a light or an alarm bell) to let you knowwhen an alarm is active on the UPS. This feature is useful if the UPS is located in aremote area where the UPS horn may not be heard immediately.C A U T I O NContacts should not be operated in excess of 30 Vac @ 5A maximum.
