UPS MAINTENANCEPower Xpert 9395 Plus 1 UPS (225–275 kVA) Installation and Operation Manual 164201710 Rev 7 www.eaton.com/powerquality9-49.2.5 BATTERY MaintenanceContact an Eaton service representative for battery maintenance. Battery replacementand maintenance should be performed only by authorized service personnel.9.3 Installing BatteriesNOTE There is no manual DC disconnect device within the UPS.Install batteries in accordance with the battery and battery cabinet or battery rackmanufacturer's instructions.9.4 Recycling the Used Battery or UPSContact your local recycling or hazardous waste center for information on properdisposal of the used battery or UPS.W A R N I N G Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper disposal of batteries isrequired. Refer to your local codes for disposal requirements. Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes. Itmay be toxic. A battery can cause electrical shock, burn from high short‐circuit current, or fire. Observe properprecautions.A T T E N T I O N ! Une batterie peut prêsenter un risque de choc êlectrique, de brulure, ou d'incendie. Suivre lesprécautions qui s'imposent. Pour le remplacement, utiliser le même nombre et modéle des batteries. L'élimination des batteries est règlementée. Consulter les codes locaux à cet effet.C A U T I O NDo not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead‐acid batteriesand must be disposed of properly. For more information, contact your local recycling/reuse or hazardouswaste center.C A U T I O NDo not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal, contact yourlocal recycling/reuse or hazardous waste center.9.5 Maintenance TrainingA basic training course, available from Eaton Corporation, gives you a competentworking knowledge of the UPS system operation and teaches you how to performfirst level corrective maintenance. For more information about training and otherservices, contact the Help Desk (see page 1-9).
