Eaton Power Xpert Meter 4000 Quick Start Manual

Contents

www.eaton.com IB02601007E Page 92 Quick Start Guide for the Meter Module2. Configure the Security Mode Dip Switches:3. Planning CT and VT Connections (Figure 3)Determine your wiring requirements for the meter module. This quick start guide will coverthese basic wiring configurations:• 3-Phase, 3-Wire Delta( Up to 600 V L-L, 347 L-N) 3CTs• 3-Phase, 3-Wire Delta (Above Up to 600 V L-L, 347 L-N) 3CTs• 3-Phase, 3-Wire Delta (Above Up to 600 V L-L, 347 L-N) 2 CTs• 3-phase,4-Wire Y (Up to Up to 600 V L-L, 347 L-N)• 3-phase,4-Wire Y (Above Up to 600 V L-L, 347 L-N)See Installation, for wiring diagrams.DS-1 DS-2 DS-3OFF OFF ON isNormal.OFF isSafeModeNo restrictions (user ID/Password re-quired)ADMIN/ADMIN accepted for 15 minutesafter boot-upOFF ON ON isNormal.OFF isSafeModeMedium Security - Energy & Demandresets prohibitedON OFF ON isNormal.OFF isSafeModeHigh Security- Configuration changes;Energy & Demand reset prohibitedON ON ON orOFFFactory Test Mode - The meter shouldnever be operated in this mode. The meterwill indicate that it’s in factory test modethrough a repeating series of three flasheson the red Status LED