Eaton Power Xpert PXM 4000 User And Installation Manual

Also see for Power Xpert PXM 4000: Quick start guide User and installation manual User manual

Contents

www.eaton.com IM02601004E Page 1056 Meter Settings Using the Web ServerSECURITY PERMISSIONSAccount permissions are defined by the Security Group to which they are assigned. The SecurityGroups range from high (1) to low (5) level security. The account’s security group must be equal to,or higher than, the group required to set security permissions in order to change security settings.For example, if the Security group permission is set to 2, then the account must have been as-signed a group of 1 or 2 in order to change security settings. However, any user may change his orher own user account security settings without this permission.The following is a list of the pages that require a Security Group to be assigned:• Security • Clear Event Logs• Wiring Configuration • Clear Min Max• Triggers • Reset All Data• Meter Configuration (Demand/IP/TOU) • Reboot• I/O Configuration • Firmware Upgrade• Communication Port Setup • Set Date & Time• Demand Reset • Set Default Configuration• Energy Reset• Start & Stop Load Profile• Acknowledge Events• Clear Events and Waveforms• Acknowledge Event LogsLocating Security Information On The Web1. From the Settings main page, select the Users tab.2. Select the Security Permissions arrow.3. Underneath the Security Permissions arrow is a list displaying all of the current settings.4. Click Edit to change any of the listed settings.5. Click Save when new entries are completed. Click Close to exit Edit mode.NOTE: Only users with the same or higher security group can edit permissions. For example, asecurity group 5 user will not be able to edit security group 4 through 1 permissions. A user with asecurity group of 1 will be able to edit all permissions.