COMMUNICATIONEATON Eaton 9395 550/275 UPS (225–550 kVA) Installation and Operation Manual 164201716 Rev 2 www.eaton.com/powerquality8-4Remote Notification differs from the basic Terminal mode with the addition thefollowing functions: Call AnswerThe Call Answer function allows the user to call into the UPS from a remotelocation and enter Terminal mode. Call OutThe Call Out function allows the UPS to be configured to call either a remotecomputer or numeric paging service over the phone line. Call Out allows the UPSto call a remote computer and leave a one‐line descriptive message of the alarm ornotice condition. Numeric paging support allows the UPS to call a paging serviceand send numeric messages. HousekeepingThe Housekeeping function maintains the link between the UPS and modem.8.5 Terminal ModeIn Terminal mode, the user can request the following functions:NOTE The brackets ([ ]) in the following bullets indicate standard keyboard characters. To use a keycombination, hold down the Escape key and press the indicated letter key. [ESC] [A] displays the Active Alarms. [ESC] [H] displays the Event History. [ESC] [N] displays the Node Bits Setup. [ESC] [Q] Quit.8.5.1 Display UPS Control PanelWhen this function is invoked, a facsimile of the UPS control panel is displayed on theterminal screen. All controls are functional and can control the UPS remotely. The onlyexception is the Load Off control which requires the operator to press and hold thelocal control for two seconds to shut down the UPS.To remotely control the UPS or view UPS information, use the Escape key legend tocontrol the function normally controlled by the control panel softkeys. Seeparagraph 7.2 on page 7-2, “Using the Control Panel,” for instructions on navigatingthe control panel.