OPERATIONEaton FERRUPS Rack Mount UPS (850 VA–7 kVA) User's Guide 164201424 Rev 1www.eaton.com/powerquality32When you lock the control panel, it beeps and displays −KeypadLocked− for approximately two seconds. The control panel beeps andshows this display whenever you try to use the keys. The front panelindicators continue to show the UPS status, and the control panel showsUPS alarms. To enable the control panel again,Press this key: Display shows:[CLEAR] and [ENTER] together Unlock #:[8] [2] [0] [4] [9] Unlock #: 82049[ENTER] Keypad UnlockedAfter approximately two seconds, the control panel shows the samedisplay it showed before you unlocked it. If you enter the wrong unlocknumber, the control panel displays −Keypad Locked− for twoseconds, and the control panel remains locked.Using the Configuration MenuThe control panel includes a Configuration Menu that lets you adjust itsbaud rate and brightness, turn the beeper on or off, turn on and off theclick you hear when you press keys, and control other features. Thelabel on the back of your control panel includes more information on thismenu (see Figure 9).Remote Control Panel (RCP)Access Instructions for Configuration MenuSimultaneously press and to enter RCPConfiguration menu[CONTROL] [PROGRAM]At any time: Press to display/edit next menu item[ENTER]Press to exit menu and save changesPress to exit menu without saving changes[PROGRAM][CLEAR]Menu Item Range NotesBaud RateBrightnessBeeperKeyclickRepeatConnect0 − 50 − 70 − 10 − 10 − 10 − 10=300, 1=1200, 2=2400, 3=4800, 4=9600, 5=19200Display brightness: 0=Min, 7=MaxBeeper enabled? 0=No, 1=YesKeyclick enabled? 0=No, 1=YesAutorepeat of depressed key? 0=No, 1=YesSend “123DCP” at startup? 0=No, 1=YesFigure 9. Remote Control Panel