Eaton T2235 Series eATS ePDUs P-164000014—Rev 1 www.eaton.com/ePDU 9Chapter 3 InstallationThe Eaton T2235 Series Automatic Transfer Switch (eATS) Enclosure Power Distribution Unit (ePDU) modelshave a 19” chassis composed of 16 gauge (Ga.), electrolytic galvanized (EG) or cold roll (CR) steel plate. TheT2235 Series eATS ePDU can be mounted on a rack or in a cabinet that accepts standard 19” width spacing.The ePDUs are installed in a 1U orientation. Installation of a T2235 Series eATS ePDU is to be performed byqualified, trained technicians.This chapter explains the following:l Equipment inspectionl Setup and installationl Front and back panel diagramsInspecting the EquipmentIf any equipment has been damaged during shipment, keep the shipping cartons and packing materials for thecarrier or place of purchase and file a claim for shipping damage. If you discover damage after acceptance, filea claim for concealed damage.To file a claim for shipping damage or concealed damage: 1) File with the carrier within 15 days of receipt of theequipment; 2) Send a copy of the damage claim within 15 days to your service representative.Checking the Accessory BagThe following parts for installing the T2235 Series eATS ePDU are located in the accessory bag:l (4) 10-32 X 1/2 Ohms Phillips head screwsl (4) #10 finishing nickel washerl (4) #10 nylon washerThe following documentation is located in the shipping carton:l User's guideCable Restraint TrayOptional equipment is not shipped with aT2235 Series eATS ePDU. Optional equipment is shipped separately.If you ordered optional accessories, verify that the associated hardware is included when the option isdelivered.The depth of your model determines which optional cable restraint tray you need to order for your eATS ePDU:l If your model is 228.6 mm or 241.3 mm (9” or 9.5”) deep, use the KIT-CABLRES-01 cable tray.l If your model is 177.8 mm (7.0”) deep, use the KIT-CABLRES-03 cable tray.KIT-CABLRES-01 Universal Cable Restraint SystemThe following parts for installing the optional cable restraint tray are located in the KIT-CABLRES-01 shippingcarton:l (1) Cable management tray (001-2211-2)l (2) Mounting brackets (001-2212-2)l (11) 6-32 X 1/4” black screws (035-1606)l (12) Tie-wraps, 8” (010-0008)