Eaton XV400 10.4" Operating Instructions Manual

Also see for XV400: Operating instructions

Contents

5 Installation5.4 Mounting38 MICRO PANEL XV400 10.4"/12.1"/15" 12/2010 MN04802010Z-EN www.eaton.com5.4 Mounting1 Check the device for damage in transit.2 If necessary, fit the required communication module in the device. See Chapter 5.4.1 Fitting thecommunication module in the device,  39.3 Mount the device in the control cabinet, control panel or the control desk: Devices with standard front, see Chapter 5.4.2,  41. Devices with 4-hole front, see Chapter 5.4.3,  46. Devices with stainless steel front, see Chapter 5.4.4,  49.4 Connect the device as required. Follow the instructions on wiring the relevant interface. See Chapter 5.3 Cable preparation, 28.CAUTIONOperational malfunctionsUse of unsuitable or improperly prepared cables, as well as incorrect wiring willmean that neither the values stated in the technical data nor the electromagneticcompatibility (EMC) can be ensured. Only use cables prepared by specialists. The cables used must be prepared according to the interface description in thisdocument. The wiring instructions for the relevant interface must be observed when wiringthe device. Any generally applicable regulations and standards must be fulfilled.CAUTIONDevice condensationIf the device is or was exposed to climatic changes (temperature fluctuation, air hu-midity) moisture can form on or in the device (device condensation). In this case,there is a risk of short-circuit. The device must not be switched on when device condensation is present. If condensation is present on the device, or if it was exposed to temperature fluc-tuations, it must be allowed to adjust to room temperature (do not expose the de-vice to the direct heat of heating devices) prior to commissioning. The device must only be installed and commissioned in perfect technical condition andin compliance with this document. The device is not provided with an On/Off switch. If the power supply is not providedwith a switch, the device will start up (boot) as soon as it is connected to the power sup-ply.