13Notes:The LCD mode adjustment makes it possible to leave the screen on whenever theCA200z is in ON mode, or for it to be DIMMED or OFF after about 20 seconds of inactivity on theuser controls.In setup mode, the options of each parameter are displayed intermittently on the LCDscreenTo access the ADVANCED SETUP mode, press and hold the special key combinationMIC1 + MIC2 + front rotary encoder knob:Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)REMOTE1ADVANCED SETUP modeSPADVANCED SETUP MODESETUP MODESP to getbackModeshown inLCDLPLP to enterthe REMOTE1control portsetup modeRotate knobto adjustREMOTE1control portworkingmodeRotate knobto browseoptions++ADVANCED MODEKEY CODE REQUIREDPress and hold MIC1 + MIC2 +front panel knob to enter theADVANCED SETUP MODELPIR REMOTEModeshown inLCDLPLP to enterthe Infraredremote controlsetupIR REMOTEON / OFFRotate knobto enableor disablethe IRREMOTEcontrolRotate knobto browseoptionsRotate knobto browseoptionsRotate knobto browseoptionsRotate knobto browseoptions Rotate knobto select anoptionAUTOLOAD PR 1ON / OFFLP to enter theAUTOLOADPRESET 1setupLPStatusshown inLCDSP to getbackAUTOLOAD PRESET 1(at every power ON)MIC2MIC1SAVE PRESET1 ... 5PRESETnumbershown inLCDSP to SAVEand getbackLP LP to enterthe PRESETSAVE modeSAVE PRESET1, 2, 3, 4 or 5Rotate knobto selectPRESETnumberLPREMOTE2 VOL + INPUTSVOL + PRESETSOFFRotate knobto adjustREMOTE2control portworkingmodeREMOTE2LP to enterthe REMOTE2control portsetup modeModeshown inLCDSP to getbackREMOTE1VOL + INPUTSVOL + PRESETSOFFSP to getbackSPSPSPSPSP