FAR KJ 45/S Original Instructions Manual

Also see for KJ 45/S: Instructions for use TRANSLATION OF ORIGINAL INSTRUCTIONS TRANSLATION OF ORIGINAL INSTRUCTIONS

Contents

GB KJ 45/SKJ 45/SDate 01-2011 Revisione - 0312INSTRUCTIONS FOR USE IINDEXGUARANTEE AND TECHNICAL ASSISTANCE ............................ 12SAFETY MEASURES AND REQUIREMENTS ............................. 12TOOL IDENTIFICATION ............................................................. 13GENERAL NOTES AND USE ...................................................... 13MAIN COMPONENTS ................................................................ 13TECHNICAL DATA ..................................................................... 13AIR FEED ................................................................................... 14PRELIMINARY OPERATIONS .................................................... 14PLACING OF THE INSERT ......................................................... 15WORKING PROBLEMS ............................................................. 16CHANGE OF SIZE ..................................................................... 17ADJUSTMENT OF TIE-ROD/HEAD UNIT................................... 18TOOPING UP THE OIL-DYNAMIC CIRCUIT ............................... 19MAINTENANCE ........................................................................ 19DISPOSAL OF THE RIVETING TOOL ......................................... 19CAUTION!!!All the operations must be done in conformitywith the safety requirements, in order to avoidany consequence for your and other peoplesecurity and to allow the best tool work way.• Read the instructions carefully before using the tool.• For all maintenance and/or repairs please contact FAR s.r.l.authorized service centers and use only original spare parts.FAR s.r.l. may not be held liable for damages from defective partscaused by failure to observe what mentioned above (EEC directive85/374).The list of the service centres is available on our websitehttp://www.far.bo.it ( Organization )• The tool must be used only by expert workers.• A protective visor and gloves must be put on when using thetool.• Use equipment recommended in the maintenance chapter to doany maintenance and/or regulation of the tool.• For topping up the oil, we suggest using only fluids in accordancewith the features specified in this working book.• If any drop of oil touches your skin, you must wash with waterand alkaline soap.ATTENTION! In case of strong impacts or accidentalfalls the machine should be completely overhauled.GUARANTEE AND TECHNICAL ASSISTANCEFAR riveting tools are covered by a 12-months guarantee.The period of guarantee starts from the date of deliveryspecified on the invoice or delivery note.The guarantee covers the user/buyer when the tool is boughtthrough an authorized dealer and only when it is employed forthe uses it was conceived for. The guarantee is not valid if thetool is not used or maintained as indicated in the instructionand maintenance handbook.In case of defects or faults FAR S.r.l. undertakes only torepair and/or replace the components it considers faulty.SAFETY MEASURES AND REQUIREMENTS• The tool can be carried and we suggest putting it into its box afterusing.• The tool needs a thorough six-monthly overhaul.• Repairing and cleaning operations must be done when the toolis not fed.• A safety balancer is suggested when it is possible.• If the A-weighted emission sound pressure level is more than70 dB (A), you must use some hearing protections (anti-noiseheadset, etc.).• The workbench and the work surface must be always clean andtidy. The untidy can cause damages to people.• Do not allow unauthorized persons to use the working tools.• Make you sure that the compressed air feeding hoses have thecorrect size to be used.• Do not carry the connected tool by pulling the hose. The holemust be far from any heating sources or from cutting parts.• Keep the tools in good conditions; do not remove either safetyparts or silencers.• After repairing and/or adjusting, make sure you have alreadyremoved the adjusting spanners.• Before disconnecting the compressed air hose from the toolmake sure that there is no pressure in the hose.• These instructions must be carefully followed.