FCI FS10A Installation & Operation Manual
Also see for FS10A: Installation & operation guideInstallation & operation guide
                                                                            | |
Contents
| 
FS10 Series8 Fluid Components International LLC1A 120 VAC/24 VDCJP5 = 2-3RELAY CONTACT RATED CURRENT:OUTPUT PULSE SOURCE OUTPUT PULSE SINKOPEN COLLECTOROUTPUT RELAY (Default Setting)2N70024.3KSOUTPUT ALARMSETPOINTOUTPUT ALARMSETPOINT10K10KGDQ3+24VDCV CCJP8 = IN JP8 = INJP5 = OUTNOTE:2N7002SGDQ3CUSTOMER POWER SOURCEAND LOAD NOT TO EXCEED50 VDC and 40 mA.2N7002S+24VGDQ3- +COILK1NONCCJP8 = OUTJP5 = 1-2FREQUENCY OUTPUT CORRESPONDINGTO FLOW WITH PULSE WIDTH AT 50%DUTY CYCLE FOR RATES 1 TO 2000 Hz.5.5 mA LOAD PULSED.RECOMMENDED LOAD RESISTOR = 10 KΩALARM FUNCTION (SETPOINT).FREQUENCY OUTPUT CORRESPONDINGTO FLOW WITH PULSE WIDTH AT 50%DUTY CYCLE FOR RATES 1 - 2000 Hz.RECOMMENDED LOAD RESISTOR = 10 KΩALARM FUNCTION (SETPOINT).SW_OUTPUTOR OUTPUTFREQUENCYSW_OUTPUTH OR HL LOR OUTPUTFREQUENCYH OR HL LOUTPUT ALARM SETPOINTSW_OUTPUTC01265-1-1Switching Inductive LoadsIf the FS10A/FS10i relay contacts are to be used to energize or de-energize an external relay, diode suppression must be used across the externalrelay coil. Use the guidelines in the following example to select the proper diode.A Tyco Electronics relay K10P-11D15-24 is used as a slave relay. The DC coil voltage is specified at 24 VDC and the specification indicates a coilresistance of 650 Ω. The DC coil current is calculated by dividing the rated coil power by the rated voltage VDC or dividing the rated voltage VDC bythe coil resistance. In this case the current through the coil will be around 37 mA (24 ÷ 650). Refer to the K10P-11D15-24 data sheet.It is recommended the diode reverse voltage (Vr) rating be twice or greater the voltage across the relay and the diode forward current (IF) rating begreater than the relay current. Diodes 1N914 or 1N4148 meet these limits for this case.FS10 Output ModesA schematic view of the FS10 output modes and corresponding jumper settings are shown below.Figure 2 – Output Modes and Jumper Settings |
Related manuals for FCI FS10A
manualsdatabase
Your AI-powered manual search engine