Falcon 1000 Mercury Dual Fuel User's Manual And Installation Instructions

Also see for 1000 Mercury Dual Fuel: User's guide & installation instructions

Falcon 1000 Mercury Dual Fuel User's Manual And Installation Instructions Manual pdf 30 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.26Electrical ConnectionThis appliance must be installed by a suitably qualifiedelectrician to comply with the relevant electrical regulations,and also the local electricity supply company requirements.Note: The cooker must be connected to the correct electricalsupply as stated on the voltage label on the cooker, througha suitable cooker control unit incorporating a double poleswitch, having a contact separation of at least 3 mm in allpoles.The cooker MUST NOT be connected to an ordinary domesticpower point.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connectthe mains cable to the correct terminals for your electricalsupply type (Fig.7-24 and Fig.7-25). Check that the links arecorrectly fitted and that the terminal screws are tight. Securethe mains cable using the cable clamp.Final ChecksHotplate CheckCheck each burner in turn (refer to the ‘Hotplate Burners’section at the front of the instructions).Grill CheckTurn on the grill control and check that the grill heats up.Oven CheckTurn on the ovens – check that the oven fans start to turn andthat the ovens start to heat up.Final FittingFitting the Bottom PanelOpen the left-hand oven door.On the front on the cooker base there are two mountingplates. Remove the three fixing screws from each plate.Fit the retaining brackets to the mounting plates and refit thescrews (Fig.7-26). DO NOT tighten at this stage.Tilt the bottom of the panel slightly to locate the lower slotsonto the washers (Fig.7-27). Now rotate the panel to fit overthe upper pins (Fig.7-28).Using the two screws provided, secure the bottom panel ontothe brackets. DO NOT tighten at this stage.Adjust the bottom panel to align it with the door panels.When it is positioned correctly, use a suitable flat open endedspanner to tighten the bracket screws, and then tighten thebottom panel screws.Customer CareInstaller: Please complete your details in this guide, informthe user how to operate the cooker and hand over theinstructions.Thank you.6 mm² max230 Vac 50 HzNL10 mm² maxFig.7-24PlinthFig.7-26Front left Front rightLocatingwasherPlinthPinFig.7-28Fig.7-27L1NL3L23N ac230/400 V 50 Hz6 mm² max10 mm² max6 mm² maxFig.7-25