Falcon Classic 110 Gas User's Manual & Installation Instructions

Also see for Classic 110 gas: User guide User guide User's guide & installation instructions

INSTALLATIONCheck the appliance is gas sound when you have finished.31ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)ArtNo.215-0026 - Handle gaskets fixedArt No 215-0028 - Handrail fascia fixingsFig. 8.18Fig. 8.19Fig. 8.20Final ChecksNote: The clock must be set before the ovens will work. See‘The Clock’ section for instructions on setting the time of day.Hotplate CheckCheck each burner in turn. There is a Flame SupervisionDevice (FSD) that stops the flow of gas to the burner if theflame goes out. For each burner, turn the control knob to thesolid flame symbol. Press in the control knob. This lets gasthrough to the burner. Keep holding the knob pressed in andpress the igniter button or light with a match. Keep holdingthe control knob pressed in for about 10 seconds.If, when you let go of the control knob the burner goes out,the safety device has not held in. Wait one minute then tryagain this time holding the control pressed in for slightlylonger.Grill CheckTurn on the grill control and check that the grill heats up.Oven CheckSet the clock as described earlier in the instructions, and thenturn on the ovens. Check that the ovens start to heat up.Note: The oven light bulb is not included in the guarantee.Turn off the ovens.Final FittingFitting the Handles and HandrailRemove the 4 mm Allen screws from the doors (Fig. 8.18). Fitthe door handles and secure using the 4 mm screws.nn The handles should be above the fixings.Remove the 4 mm Allen screws from the top corners of thefascia (Fig. 8.19). Fit the handrail in position and secure usingthe 4 mm screws.Fitting the PlinthFit the inner plinth to the bottom front of the cooker usingthe 4 screws provided (Fig. 8.20).Fit the outer plinth (2 screws, 1 each end) to the inner plinth(Fig. 8.21). Adjust the height of the outer plinth by sliding itup or down via the slotted hole.Fitting the SplashbackPosition the splashback on the rear of the hotplate and securewith the screws supplied.Customer CareInstaller: Please complete your details in this Guide, informthe user how to operate the cooker and hand over theinstructions.Thank you.ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)Outer plinthOuter plinth fixing screwInner plinthFig. 8.21