Falcon Classic 110 Gas User's Manual & Installation Instructions

Also see for Classic 110 gas: User guide User guide User's guide & installation instructions

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.406.3 To Adjust an Oven Door AngleThe bottom hinge of either oven door can be adjusted toalter the angle of the door (Fig. 10.11). Loosen the bottomhinge fixing screws and use the notch and a flat bladedscrewdriver to move the position of the hinge to set thehinge position (Fig. 10.12).Retighten the hinge screws.6.4 To Replace an Oven Door Outer PanelMove the cooker forwards to gain access to the sides.Open the oven door slightly and remove the 4 front panelfixing screws from the door sides (2 each side), (Fig. 10.13).Carefully lift off the outer door panel.Remove the door handle from the panel by unscrewing the 2retaining nuts.Fit the door handle to the new panel.Fit the panel to the door. Reassemble in reverse order.6.5 To Change the Oven Door LatchRemove the outer door panel (see 6.4). Remove screws ‘B’,which hold the latch assembly to the inner door panel (Fig.10.14). Fit the new catch and reassemble in reverse order.Check the door operation.6.6 To Adjust an Oven Door Catch KeepOpen the oven door, slacken off the locknut at the base of thekeep, and screw in or out as required until the required fit isobtained. Retighten the locking nut(Fig. 10.15).6.7 To Change an Oven Door SealOpen the oven door. The seal is held in place by small hookson the rear face. At the corner, pull the seal diagonally awayfrom the door centre until that hook is released (Fig. 10.16).Proceed to the next hook and release it in a similar way, andso on. Use force if the hooks are stiff, as the old seal will bediscarded.When fitting the new seal, position the seal join at thebottom. Hook the new seal in one of the corner holes of thedoor, and proceed round the door, snapping in each hook inturn.6.8 Oven Door GlassThe glass on the oven doors is not replaceable.ArtNo.320-0002a Proplus oven door side screwsArtNo.320-0006 Oven door hinge adjustment 1ArtNo.320-0007 Oven door hinge adjustment 2Effect of hinge adjustment – exagerrated for clarityCentreline of hinge pinOven door omitted for clarityArtNo.320-0003 Oven door latchBArtNo.320-0004 Oven door keepArtNo.320-0005 Oven door rubber sealFig. 10.11Fig. 10.12Fig. 10.13Fig. 10.14 Fig. 10.15Fig. 10.16