Falcon Continental Dual Fuel FSD User's Manual & Installation And Servicing Instructions

SERVICING  WARNINGDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.19Conversion to LPIf the appliance is to be converted to LP gas do the conversionat this point. See the conversion section of these instructions.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The rollers can be adjusted to level the cooker. To adjust theheight of the rear of the cooker use the levelling tool suppliedto turn the adjusting nuts at the front bottom corners of thecooker.Adjust the height of the front roller to level the cooker. Turnclockwise to raise the cooker and anticlockwise to lower.When you are satisfied with the height and level raise the frontof the cooker by one turn of the front roller adjuster. Screwdown the front feet to meet the floor. Screw the front rolleradjuster anticlockwise to raise the front roller so that the frontof the cooker is supported on the feet, not the front roller, toprevent accidental movement of the cooker.Gas ConnectionFitting a stability bracketA stability bracket or chain (not supplied by with the cooker)should be fitted when the cooker is connected to a flexible gassupply. Any restraining device should be secured to the fabricof the building and should be able to be released so that thecooker can be pulled out for cleaning and maintenance.When fitting a stability bracket read these instructions togetherwith the leaflet supplied with the bracket.1. Place the cooker in its intended position and level thecooker.2. Draw a pencil line 100mm from the front edge of thelevelling feet.3. Mark the centre line for the bracket by measuring 550mmfrom the left hand side of the cooker.4. Lower the front roller and move the cooker forward.5. Measure back from the pencil line 550mm to locate thefront edge of the bracket. Fix the bracket to the floor.6. Measure the height from floor level to engagementedge in back of cooker. Add 3mm to this dimension andassemble the stability bracket to this height. (i.e. fromfloor level to underside of the top member) and ensurethe bracket does not foul the oven burner assembly.)Gas ConnectionA gas shut off valve must be fitted between the gas supply andthe connection hose. The flexible hose (not supplied with thecooker) must be in accordance with the relevant standards. If indoubt contact, your supplier.view from the rearA position of pressure test point screwB appliance gas inletC position for gas supply connector