Fantasy Spas ILLUSION Owner's Manual
                     | |
Contents
| 
11Preset Filter CyclesThe first filter cycle begins 6 minutes after the spa is energized. The second filter cycle begins 12 hours later. Filter durationis programmable for 2, 4, 6, 8, or 12 (FC) for continuous filtration. The default filter time is 2 hours. To program, pressTemp/Down or Up then press “Jets”. Press Temp/Down or Up to adjust.. Press “Jets” to exit programming. Pump low speedwill run for the duration.The low speed of the pump runs during filtration and the ozone generator (if installed) will be enabled.Freeze ProtectionIf the temperature sensors detect a drop to below 44°F (7º C) within the heater, the pump will automatically activate toprovide freeze protection. The equipment stays on until 4 minutes after the sensors detect that the spa temperature has risen to44°F (7º C) or higher. In colder climates, an optional additional freeze sensor may be added to protect against freezeconditions that may not be sensed by the standard sensors. Aux freeze sensor protection acts similarly except with thetemperature thresholds determined by the switch and without a 4-minute delay in turnoff. See your dealer for details.Diagnostic MessagesOverheat condition OHWARNING! DO NOT ENTER HOT TUBWater is too hot. Overheat protection. Heater is deactivated. Spa water temperature is above acceptable limits. When the actualwater Temperature is approximately 2º F (1º C) above the set temperature, the circulation pump will stop operating to reduce(frictional) heating. If the spa water temperature continues to rise and gets above 110º F (44ºC), the spa will go into an “OH” overheatcondition.To correct Condition:1. Remove the spa’s cover and allow your spa to cool down.2. Reduce the temperature setting.3. When the water temperature drops below 106º F (41ºC), the spa will resume normal operation.4. If the water does not drop below 106ºF (41ºC), contact your authorized dealer.Refer to the Control Reference Card provided by Fantasy in your packet.* Note: Fantasy has designed the control panel, topside, to include:1) Jets button2) Light button3) Down heat button4) Up Heat button(Fantasy Spas currently does not offer air blowers.)Warning! Shock Hazard! No User Serviceable Parts.Do not attempt service of this control. Contact your dealer or service organization for assistance. Follow all owner manualpower connection instructions. Installation must be performed by a licensed electrician and all grounding connections mustbe properly installed. |
Related manuals for Fantasy Spas ESPIRIT
manualsdatabase
Your AI-powered manual search engine