5A Good FoundationYour new hot tub needs a good solid foundation. The area your hot tub sits on must be able tosupport the tub, the water in it and those who use it. If the foundation is inadequate, it mayshift or settle after the hot tub is in place, causing stress to the shell or components.BE AWARE:Damage caused by inadequate or improper foundation support is not covered by the hot tubwarranty. It is the sole responsibility of the hot tub owner to provide a proper foundation forthe hot tub.Make sure the foundation where the hot tub is placed drains water away from the hot tub.Proper drainage will keep components dry from rain and wet weather.If you choose to install your hot tub indoors, pay close attention to the flooring beneath it.Always remember a hot tub is filled with water. Choose flooring that will not be spoiled orruined from water damage. Check with your contractor to verify your flooring can support theweight and water spills or splashing from your hot tub.Your hot tub weight must always be considered when installing your hot tub. If you areinstalling it on an elevated wood deck or other structure, it is advisable to consult a structuralengineer or contractor to ensure the structure will support the weight.IT IS STRONGLY RECOMMENDED THAT A QUALIFIED, LICENSEDCONTRACTOR PREPARE THE FOUNDATION FOR YOUR HOT TUB.There is a 4” (10cm) minimum depth requirement for a concrete pad.Placing the Hot TubCHECK THE DIMENSIONS OF YOUR HOT TUBCompare the hot tub dimensions to the width of gates, sidewalks, and doorways along thedelivery route used to bring the hot tub into your yard. It may be necessary for you to removea gate or partially remove a fence in order to provide an unobstructed passageway to theinstallation location.Also, keep in mind—if you are using special equipment to place your hot tub into an area itwill be necessary to include those measurements and weights.PLANNING A DELIVERY ROUTE:Check the width of gates, doors and sidewalks to make sure your hot tub will pass throughunobstructed. You may need to remove a gate or part of a fence to allow for adequate widthclearance.If the delivery route will require a 90 degree turn, check the measurements at the turn to ensurethe hot tub will fit.Check for protruding gas meters, water meters, A/C units, etc., on your home which will causeobstructions along the delivery path to your yard.Check for low roof eaves, over hanging branches or rain gutters that could be an obstruction tooverhead clearances.SPECIAL CIRCUMSTANCESThe use of a crane for delivery and installation is primarily to avoid injury to your hot tub, yourproperty or to delivery personnel. Your dealer may be able to assist you with thearrangements. Cranes are not considered “normal delivery” and would need to be a specialtyrequest.