FARO® Laser Scanner Focus3D X 130 ManualJanuary 201445Chapter 5: Getting StartedSetting the Scan Range(Home > Parameters> Horizontal / Vertical)Vertical area - The size of the vertical scan area in degrees. Use the left up anddown buttons to change the vertical start angle, use the right up and down buttonsto adjust the vertical end angles.Horizontal area - The size of the horizontal scan area in degrees. Use the leftbuttons to change the horizontal start angle, use the right buttons to adjust thehorizontal end angles.Default Area button - Click to reset the values to the default scan area (verticalfrom -60° to 90° and horizontal from 0° to 360°).The rectangle in this view illustrates the full scan area. If there are scans on theinserted SD card, the preview picture of the last recorded scan is displayed. Ifthere is no preview picture available, a grid is displayed, where the spacebetween the horizontal and vertical lines is equivalent to 30°. The yellowrectangle illustrates the selected scan area.Figure 5-19 Setting the Scan Range
