Installation of the range.50Operating InstructionsInstallation InstructionsSafety InformationTroubleshooting TipsCustomer ServiceRead these instructions completely and carefully.Anti-Tip Bracket InstallationAnAnti-Tip bracket is supplied with instructions for installation in a varietyof locations. The instructions include a template, a parts list and a list of toolsnecessary to complete the installation. Read theImportant Safety Informationand the instructions that fit your situation before beginning installation.WARNINGn Range must be secured byAnti-Tip bracket supplied.n See instructions to install (supplied with bracket).n Unless properly installed, the range could be tipped by stepping or sitting onthe door. Injury might result from spilled hot liquids or from the range itself.8Typical installation of anti-tip bracket attachment to wall.BracketScrew must enter wood or metalWall plateLeveling the RangeThe range must be level. Leveling feet are located at each corner of the base ofthe range. Remove the storage drawer or kick panel (depending on your model)and using channel locks, rotate the leveling feet in and out as required to levelthe range. (For instructions on how to remove and replace the storage drawer orthe kick panel, see theCare and cleaning of the range section.)On some models, there are plastic covers which may be removed for easyadjustment (just squeeze and pull).One of the rear leveling feet will engage theAnti-Tip bracket (allow for some sideto side adjustment). Allow a minimum clearance of 1/8≤ between the range andthe leveling foot that is to be installed into theAnti-Tip bracket.Check the range for proper installation into theAnti-Tip bracket by removing thekick panel or storage drawer and inspecting the rear leveling leg. Make sure it fitssecurely into the slot.9Final CheckBe sure all range controls are in the OFF position before leavingthe range.10