GE GFDR485GF Technical Service Manual

Also see for GFDR270EH: Dimensions and installation information Technical service guide

GE GFDR485GF Technical Service Manual Manual pdf 37 page image

375. Remove the drum lamp.6. Remove the front drum support.7. Remove the belt.8. Pull the drum out the front of the dryer.9. Remove the inlet ring.10. Remove the 14 mm reverse thread blower wheelback-up nut.11. Unscrew the reverse thread blower wheel.12. Unhook the idler pulley spring and spread thepulley apart.13. Remove the motor wire harness.14. Remove the two motor mounting clips.15. Remove the motor.Belt SwitchBelt Switch Removal1. Disconnect power from the unit.2. Remove the control panel.3. Remove the front panel.4. Remove the trap duct.5. Remove the drum lamp.6. Remove the front drum support.7. Remove the belt.8. Pull the drum out from the front of the dryer.9. Remove the two idler switch wires.10. Remove the T-8 mounting screw.11. Remove the belt switch.12. NOTE: When reinstalling, make sure the align-ment pin is in the second hole of the belt switch.See Trap Duct Removal on page 38.See LED Drum Lamp Removal on page 33.See Incandescent Drum Lamp Removal onpage 34.See Front Drum Support Removal on page 34.See Inlet Ring Removal on page 39.See Control Panel Removal on page 20.See Front Panel Removal on page 24.See Trap Duct Removal on page 38.See LED Drum Lamp Removal on page 33.See Incandescent Drum Lamp Removal onpage 34.See Front Drum Support Removal on page 34.