GE GFT14 Owner's Manual & Installation Instructions

Also see for GFT14: Owner's Manual & Installation Instructions

Contents

49-90571-1 21Installation InstructionsINSTALLING THE STACK BRACKET KITINSTALL DRYER AND BRACKETON DRYERA. Lift the dryer on top of the washer. Protect thewasher control panel with cardboard or otherprotection. Be sure to lift the dryer high enough toclear the washer control panel.B. Align the holes in the bracket with the holes in theback of the dryer. Using a Phillips screwdriver,attach the 2 #8 x 1/2” tapping screws.2Failure to do so may result in back or other injury,or property damage.• Use two or more people to install dryer.• Avoid tipping and rupture of utility services.• Dryer must be securely attached to the washer.• DO NOT place the washer on top of the dryer.WARNING - Excessive WeightHazardDisconnect power before installing.Failure to do so could result inserious injury or death.WARNINGFINALIZE THE INSTALLATIONA. Refer to the washer Installation Instructions tocomplete the washer installation.B. Refer to the dryer Installation Instructions tocomplete the dryer installation.C. Carefully slide or walk the stacked washer anddryer into place. Use felt pads or other slidingdevice to assist moving and to protect flooring.3PlacehandsherePlacehandshereWasherDryerDo not push on the dryer onceinstalled to top of the washer.Pushing on the dryer may result in pinched fingers.CAUTIONINSTALL BRACKET TO WASHERA. Remove washer top cap screw from the rearleft. Align left bracket holes with top cap screwhole on rear left of the unit and replace screw.NOTE: Leave screws loose so dryer holealignment will be easier.B. Drive next screw through the bracket into therear of the washer.C. Repeat the above steps with the right side.1 INSTALL DRYER AND BRACKETON DRYER (CONT.)C. Tighten the dryer bracket screws; then tighten allstacking kit screws.2WasherTopShort screws intobrackets and washerLong screws intobrackets and dryer