GE GFT14 Owner's Manual & Installation Instructions

Also see for GFT14: Owner's Manual & Installation Instructions

Contents

6 49-90571 -1Getting startedUSING THE DRYERExtended TumbleMinimizes wrinkles by adding approximately 2 hours of no-heat tumbling after clothes aredry.The estimated time remaining display will show “END”.The extended tumble time does not get added to the cycle time on the display.HD LevelThe sensor continuously monitors the amount of moisture in the load. When the moisture inyour clothes reaches your selected dry level, the dryer will stop.NOTE: Sensor dry Level can be used with all cycles except Timed Dry, Air Fluff, RackDry, Warm Up and Dewrinkle.E Damp AlertThis option causes the dryer to beep when clothes have dried to a damp level. Removeitems that you wish to hang dry. The Damp Alert will only beep when this option is selected,and the dryer will continue to dry.Removing clothes and hanging them when they are damp can reduce the need to iron someitems.DampAlertF Timed Dry1. Select the drying time by pressing the Timed Dry button. Rotate the knob to increase ordecrease the time in 10-minute increments up to 2 hours and 30 minutes.2. Select the dry Temp.3. Close the door.4. Press Start/Pause.G My CycleSet up your favorite combination of settings and save them here for one touch recall. Thesecustom settings can be set while a cycle is in progress.To store a My Cycle combination of settings:1. Select your drying cycle.2. Change Temp and Level settings to fit your needs.3. Select any drying options you want.4. Press and hold the My Cycle button for 3 seconds to store your selection. A beep willsound and the button will light up.To recall your stored My Cycle combination:Press the MY CYCLE button before drying a load.To change your stored My Cycle combination:Repeat steps 1–4.My CycleHold to SetLevelEx Dry Use for heavy-duty fabrics or items that should be very dry, such as towels.Dry Use for normal dryness level suitable for most loads. This is the preferred cyclefor energy saving.Damp For leaving items partially damp.TimedDryTumbleExt