GE GHDA690P02BB Installation Instructions Manual

Installation Instructions[ STEP ] 6 ]DISHWASHER WETTEST[] Turn on power supply(or plug power cord into outlet, if equipped).[] Select " Normal wash" program.[] Close the door.[] Checkto be sure that water enters the dishwasher.if water does not enter the dishwasher, checkto be sure thatwater and power are turn on.[] Check for leaks under the dishwasher.if a leak is found,turn power supply off, then tighten connections.Restorepower afterleak is corrected.[] Check for leaks.around the door. Aleakaroundthe door could be caused by door rubbing or hitting againstadjacent cabinetry. Reposition the dishwasher if necessary.See step 9.[] The dishwasher will drain and turn off about 5 to 7 minutes after the first fill.C heck dain lines, if leaks are found,turnpower off at the breaker and correct plumbing as necessary.Restore power ater corrections are made.See Step 12.[] Open dishwasher door and make sure most of the water has drained.if not,checkthat disposer plug has beenremoved and/or air gap is not plugged.See Step 13.Also chek drain line for kinking.[] Run the dishwasher through another fill and drain cycle .Check for leaks and correct if require.[] At the end of drain, Press reset button.[STEP]7 ] REPLACETOEKICK2-ScrewsAdjust Up.ii .......................or Downelnstall 2 toekiok screws to fasten toekiok. Allow the toe kick to tuch the floor.[STEP]8 ] LITERATUREBe sure to leave complete literature package and installation instructions with consumer.NOTE:The manufacturer, following a policy of constant development and up-dating of the product,may makemodifications without giving prior notice.12

/ 12

Related manuals for GE GHDA690P01BB