GE GLDA690 Owner's Manual

Also see for GLDA690: Owner's manual Owner's manual Owner's manual Technical service guide Owner's manual

ge.com_JStart/ResetDCloseand latch the dishwasherdoor and selectthe cycle and desiredenhancements. Touch theSTART/RESETpadto begin the cycle.The water fill begins immediately, and approximately 60 seconds laterthe wash action begins.When the dishwasher door isfully closed and latched,the control panel lights will display the last settingsyou selected. If you don't want to change any of the settings, siimply touch the START/RESETpad to beginthe cycle.If the door is closed,the indicator lights will turn off if the START/RESETpad is not selectedwithin 5 minutes.Toactivate the display, open and close the door or pressany pad.DELAY HOURSRESETYou can delay the start of a wash cycle for up to 6 hours. Pressthe DELAYSTARTpad to choose the number of hours you want to delay the start of the cycle; thenpressSTART/RESET.The machine will count down and start automatically at the correct time.NOTE:To cancel the DELAYSTARTselection before the cycle begins, repeatedly presstheDELAYSTARTpad until the display is blank.To change a cycle after washing starts:Touch the START/RESETpad to cancel the cycle. TheSTART/RESETlight will flash whilethe water is pumped out, if needed.This takes approximately 2 minutes.Time Remaining Display (on some models)During operation, the display shows the minutes remaining until the cycle is complete. The displaymay adjust the remaining time while the SENSINGlight is on. The time displayed at the start of eachcycle may change from the factory setting as the unit customizes itself to home use. During a delaystart, the display will show hours of time remaining until the cycle starts.CleanThe CLEANlight is illuminated when the selected cycle and enhancements are complete. The light willstay ON until a pad is pressed or the door is opened and then closed.