24Questions?Use thisproblemsolver!PROBLEM POSSIBLE CAUSEGRILL WON’T LIGHT • Check to see if other burners on the unit operate.WHEN THE ROTARY • Remove the grill rack and the stainless steel radiant tray, and watchIGNITER IS TURNED the igniter tip. You should see a spark jump from the tip of the igniterwhen the knob is turned. If there is no spark check to ensure there isgas supplied to the unit.• Use a match to light the burner. (See the “To light the grill” section).• Visually check the electrode and wire while turning the igniter.The only place a spark should appear is at the electrode tip.If the electrode or wire leaks voltage, remove and replace.• Purge the gas line of any air.• Check the orifice for blockage.• Inspect the igniter tip to make sure it is clean and free from debris.Clean the area. Readjust for 1/8″ gap.BURNER FLAME IS • Check the burner inlet for obstructions.YELLOW OR ORANGE • Check the air shutter for proper adjustment.IN CONJUNCTION (See the “Installation Instructions”).WITH THE ODOR • Placement of the cooking center is important for proper burnerOF GAS operation. Do not place the cooking center in a dusty area.LOW HEAT WITH • Inspect the fuel hose to ensure it is not bent or kinked.CONTROL KNOB IN • Adequate gas supply may not be available. Check to make sure thereTHE HI POSITION is gas in the LP tank (on some models).• If it is only one burner that appears low, the burner or burner orificemay need cleaning.• The air shutter may need adjustment.• Preheat the grill for 15 minutes with the lid closed.ROTISSERIE BURNER • Check for a spark at the igniter.WON’T LIGHT • Use a match to light the burner.(on some models)OPTIONAL • Readjust the thermocouple so that it is not bent or kinked, butROTISSERIE LIGHTS lies flat against the burner.BUT WILL NOT HOLD • Hold the safety valve button in until the burner remains lit.FLAME ONCEBUTTON IS RELEASED(on some models)The Problem SolverStainless Steel Outdoor Cooking Center