GE IC3645SR4R333AS1 Installation And Operation Manual

DIAGNOSTIC STATUS CODESSX TRANSISTOR CONTROL Page 20April 1999TRACTIONSTATUS CODEDESCRIPTION OF STATUS CAUSE OF STATUS INDICATION-15 Battery voltage is too low or controlcard is mis-adjusted.This status code will be displayed when the batteryvolts are less than 1.95 volts per cell at initial keyswitch on. See table below.MEMORY RECALLNO CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAMCircuits validforTractionControllerSYMPTOMControl will not operate.POSSIBLE CAUSEDischarged battery•= Check battery for proper open circuit voltageas shown in “Trouble Shooting Diagram”,charge battery, if required.Defective battery•= Check each battery cell for proper voltage(greater than 1.95 volts at cell). Replace orrepair battery.Incorrect control card adjustment.•= Check Function 15 for proper adjustment forbattery being used. See Handset instructionsheet for details. Adjust to proper settings.Check “minimum” battery volts at P1 and NEG.NEG+-FU3P1NOMINALBATTERYVOLTAGEMINIMUMLIMIT VOLTSAT 1.95 VDCPER CELL248048723623.478.046.870.235.1TRACTIONSTATUS CODEDESCRIPTION OF STATUS CAUSE OF STATUS INDICATION-16 Battery voltage is too high or controlcard is mis-adjusted.This status code will be displayed when the batteryvolts are greater than 2.4 volts per cell at initial keyswitch on. See table below.MEMORY RECALLNO CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAMCircuits validforTractionControllerSYMPTOMControl will not operate.POSSIBLE CAUSEIncorrect control card adjustmentCheck Function 15 for proper adjustment forbattery being used. See Handset instructionsfor details. Adjust to proper setting.Battery over charged or incorrect battery used.•= Check battery for proper open circuit voltageper table at right. If voltage is excessive, checkbattery charger for proper output voltage.Check “maximum” battery volts at P1 and NEG. NEG+-FU3P1NOMINALBATTERYVOLTAGEMAXIMUMLIMIT VOLTSAT 2.40 VDCPER CELL248048723628.896.057.686.443.2