8Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsBe sure you turn the control knob toOFF when you finish cooking.Using the surface units.How to SetPush the knob in and turn in eitherdirection to the setting you want.At both OFF and HI the control clicksinto position. You may hear slight clickingsounds during cooking, indicating thecontrol is keeping the power level you set.A HOT SURFACE indicator light, onthe cooktop, will glow when any radiantelement is turned on. It will remainon until the surface is cooled toapproximately 65.5°C (150°F).Hot surface indicator light will: come on when the unit is hot to the touch. stay on even after the unit is turned off. glow until the unit is cooled to approximately65.5°C (150°F).WARNING: The surfaceunits are automatically disabled duringthe self-clean cycle. Make sure that allsurface unit controls are turned off at alltimes during the self-clean cycle. Anysurface unit that is set to an on position,while the self-clean cycle is operating, willautomatically come on after the self-cleancycle is finished, and could result in anon, unattended surface unit. Wait untilthe self-clean cycle is finished to set anduse the surface units.Using the Bridge Burner (on some models)To use the bridge burner, turn theleft front control knob clockwise to theBRIDGE BURNER settings.For full bridge surface unit operation,also turn on the left rear surface unit.To use only the front surface unit, turnthe control knob counterclockwise to theFRONT BURNER settings.Dual Surface Unit Control Knob (on some models)The right front surface unit has 2 cooking sizes(22.9 cm and 30.5 cm [9 ″ and 12 ″]) to select fromso you can match the size of the unit to the sizeof the cookware you are using.To use the small surface unit, turn thecontrol knob counterclockwise to theSMALL BURNER settings.To use the large surface unit, turn thecontrol knob clockwise to the LARGEBURNER settings.30.5 cm(12")22.9 cm(9")