26Wire cover holder.Care and cleaning of the range.Oven Light ReplacementCAUTION: Before replacing youroven light bulb, disconnect the electrical powerto the range at the main fuse or circuit breakerpanel.Be sure to let the light cover and bulbcool completely.To remove the cover:Hold a hand under the cover so itdoesn’t fall when released. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Do not remove any screws to removethe cover.Replace bulb with a 40-wattappliance bulb.To replace the cover:Place it into groove of the lightreceptacle. Pull wire forward to thecenter of the cover until it snapsinto place.Connect electrical power to therange.Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsTo remove the storage drawer:Pull the drawer out all the way.Tilt up the front and remove it.To replace the storage drawer:Insert glides at the back of the drawerbeyond the stop on range glides.Lift the drawer if necessary to inserteasily.Let the front of the drawer down,then push in to close.Clean under the range.Storage Drawer Removal (on some models)