GE JCBP66SPSS Owner's Manual

Also see for ECBP82: Owner's manual and installation instructions

8Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsUsing the surface units.Be sure you turn the control knob toOFF when you finish cooking.Dual Surface Unit Control Knob (on some models)The right front surface unit has 2 cooking sizes(15.2 cm [6″] and 22.9 cm [9″] or 22.9 cm [9″] and30.5 cm [12″] depending on model) to select fromso you can match the size of the unit to the size ofthe cookware you are using.On some models, the left front surface unitalso has 2 cooking sizes (12.7 cm [5″] and 20.3 cm[8″] or 15.2 cm [6″] and 22.9 cm [9″] dependingon model).To use the small surface unit, turn thecontrol knobcounterclockwise to theSMALL BURNER settings.To use the large surface unit, turn thecontrol knobclockwise to theLARGEBURNER settings.How to SetPush the knob in and turn in eitherdirection to the setting you want.At bothOFF andMAX the controlclicksinto position. You may hear slightclickingsounds during cooking, indicating thecontrol is keeping the power level you set.AHOT surface indicator light, onthe cooktop, will glow when any radiantelement is turned on. It will remainon until the surface is cooled toapproximately 65.5°C (150°F).Hot surface indicator light will:■come on when the unit is hot to the touch.■stay on even after the unit is turned off.■glow until the unit is cooled to approximately65.5°C (150°F).WARNING: The surfaceunits are automatically disabled duringthe self-clean cycle. Make sure that allsurface unit controls are turned off at alltimes during the self-clean cycle. Anysurface unit that is set to an on position,while the self-clean cycle is operating, willautomatically come on after the self-cleancycle is finished, and could result in anon, unattended surface unit. Wait untilthe self-clean cycle is finished to set anduse the surface units.30.5 cm (12")or22.9 cm (9")22.9 cm (9")15.2 cm (6")or20.3 cm (8") 12.7 cm (5")22.9 cm (9")or15.2 cm (6")orUsing the Bridge Burner (on some models)To use the bridge burner, turn theleft front control knobclockwise to theBRIDGE BURNER settings.For full bridge surface unit operation,also turn on the left rear surface unit.To use only the front surface unit, turnthe control knobcounterclockwise to theFRONT BURNER settings.