GE JRP80 Owner's Manual

Also see for JBP80: Owner's manual Installation instructions Installation instructions Owner's manual Installation instructions

GE JRP80 Owner's Manual Manual pdf 24 page image

24Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsCare and cleaning of the range.Oven Heating ElementsDo not clean the bake element or the broilelement. Any soil will burn off when theelements are heated.To clean the oven floor, gently liftthe bake element. Clean with warmsoapy water.Oven ShelvesClean the oven shelves with an abrasivecleanser or steel wool. After cleaning,rinse the shelves with clean water and drywith a clean cloth.To make the shelves slide more easily,apply a small amount of vegetable oilto a paper towel and wipe the edges ofthe oven shelves with the paper towel.Do not spray with Pam® or other lubricantsprays.Broiler Pan & GridDo not clean the broiler pan or grid in a self-cleaning oven.After broiling, remove the broiler panfrom the oven. Remove the grid from thepan. Carefully pour out the grease fromthe pan into a proper container.Wash and rinse the broiler pan and gridin hot water with a soap-filled or plasticscouring pad.If food has burned on, sprinkle the gridwith detergent while hot and cover withwet paper towels or a dishcloth. Soakingthe pan will remove burned-on foods.Both the broiler pan and grid may becleaned with a commercial oven cleaner.Both the broiler pan and grid can also becleaned in a dishwasher.After broiling, remove the broilerpan from the oven. Do not store asoiled broiler pan and grid anywherein the range.Storage Drawer RemovalTo remove the drawer:Pull the drawer out until it stops.Lift the front of the drawer until thestops clear the guides.Remove the drawer.To replace the drawer:Place the drawer rails on the guides.Push the drawer back until it stops.Lift the front of the drawer and pushback until the stops clear the guides.Lower the front of the drawer andpush back until it closes.Stop guideRailOven Light ReplacementCAUTION: Before replacing your ovenlight bulb, disconnect the electricalpower to the range at the main fuse orcircuit breaker panel.Be sure to let the light cover and bulbcool completely.To remove the cover:Hold a hand under the cover so itdoesn’t fall when released. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Do not remove any screws to remove the cover.Replace bulb with a 40-wattappliance bulb.To replace the cover:Place it into groove of the lightreceptacle. Pull wire forward tothe center of the cover until itsnaps into place.Connect electrical power tothe range.Wire cover holder.NOTE: We do not recommend leaving theshelves in the oven during a self-cleaning cycle.The oven shelves may be cleaned in the self-cleaning oven. However, the shelves will darkenin color, lose their luster and become hard toslide if cleaned during the self-cleaning cycle.