GE JVM3150 Installation Instructions Manual

Also see for JNM3151: Owner's manual Owner's manual Installation instructions

GE JVM3150 Installation Instructions Manual Manual pdf 10 page image

10ALIGNING THE WALL PLATEDraw a vertical line on the wall at the center of the 30”wide space.Use the mounting plate as the template for the rearwall. Place the mounting plate on the wall, makingsure that the tabs are touching the bottom of thecabinet or the level line drawn in Step C for cabinetswith front overhang. Line up the notch and center lineon the mounting plate to the center line on the wall.While holding the mounting plate with one hand,draw circles on the wall at holes A, B, C and D (seeillustration above/actual plate marked with arrows). Fourholes must be used for mounting.NOTE: Holes C and D are inside area E. If neitherC nor D is in a stud, find a stud somewhere in area E anddraw a fifth circle to line up with the stud. It is importantto use at least one wood screw mountedfirmly in a stud to support the weight of the oven.Set the mounting plate aside.Drill holes on the circles. If there is a stud, drill a 3/16” holefor wood screws. For holes that don’t line up with a stud,drill a 5/8” hole for toggle bolts.NOTE: DO NOT MOUNT THE PLATEAT THIS TIME.234Draw aVertical Lineon Wall fromCenter of TopCabinetArea EHole AHole BHole DD.Installation InstructionsCAUTION: Weargloves to avoid cuttingfingers on sharp edges.1Hole CNOTE: Appearance andshape of the mountingplate may vary from yourmodel.