GE JVM3150 Installation Instructions Manual

Also see for JNM3151: Owner's manual Owner's manual Installation instructions

GE JVM3150 Installation Instructions Manual Manual pdf 16 page image

16USE TOP CABINET TEMPLATE FORPREPARATION OF TOP CABINETB4. Read the instructions on the TOP CABINET TEMPLATE. Tape it underneath the top cabinet. Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION: Wear safety goggles whendrilling holes in the cabinet bottom.WallMountingPlateSpacing for Toggles MoreThan Wall ThicknessToggleBoltToggle WingsTo use toggle bolts:Bolt EndInstallation InstructionsYou need to drill holes for the top support screws and ahole large enough for the power cord to fit through.Place the mounting plate against the wall and insertthe toggle wings into the holes in the wallto mount the plate.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touch thebottom of the cabinet when pushed flush against thewall and that the plate is properly centered under thecabinet.CAUTION: Be careful to avoidpinching fingers between the back of themounting plate and the wall.Tighten all bolts. Pull the plate away from the wall tohelp tighten the bolts.34ATTACH THE MOUNTING PLATETO THE WALLB3.Attach the plate to the wall using toggle bolts. At leastone wood screw must be used to attach the plate to awall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate through theholes designated to go into drywall and reattach thetoggle wings to 3/ 4” onto each bolt.12