GE JVM3150 Installation Instructions Manual

Also see for JNM3151: Owner's manual Owner's manual Installation instructions

GE JVM3150 Installation Instructions Manual Manual pdf 8 page image

8Find the studs, using one of the followingmethods:A. Stud finder – a magnetic device whichlocates nails.ORB. Use a hammer to tap lightly across themounting surface to find a solid sound.This will indicate a stud location.After locating the stud(s), find the center byprobing the wall with a small nail to find theedges of the stud. Then place a mark halfway betweenthe edges. The center of any adjacentstuds should be 16” or 24” from this mark.Draw a line down the center of the studs.THE OVEN MUST BE CONNECTED TO AT LEAST ONEWALL STUD.1Remove the turntable, installation instructions,filters, exhaust adaptor, damper, shelf and the smallhardware bag. Do not remove the foam packingprotecting the front of the oven.Fold back all 4 carton flaps fully against carton sides.Then carefully roll the oven and carton over ontothe top side. The oven should be resting in the foampacking.REMOVING THE OVEN FROM7+(&$57215(029,1*7+(MOUNTING PLATEFINDING THE WALL STUDSB .A .2PLACEMENT OF THE MOUNTING PLATE1WallStudsCenter3CartonPull the carton up and off the oven.Open the oven door and remove any packingmaterial, if present, from inside the oven.Foam packingInstallation Instructions236Set the oven upright. Remove and properly discardplastic bags and foam packing.51The mounting plate is attached to the back of theoven. Remove the two screws holding it to the oven.The plate will be used as the rear wall template andfor mounting the oven to the wall.4