4-50 L30 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUALFRONT PANEL INTERFACE CHAPTER 4: INTERFACES4Figure 4-53: Standard front panel label designer (LEDs shown)4. Optionally save the changes by clicking the Save icon on the toolbar.5. Click the Print icon on the toolbar. Consider printing to PDF format and adjusting the zoom for appropriate label size,then print on a physical printer.6. Cut labels as a block or individually, for example with scissors or an Exacto knife.7. If there is a plastic cover over the front panel, remove it by gently pushing in on the right side and lifting off the cover.8. Remove the plastic cover over the LEDs or pushbutton(s) using a screw driver.9. Insert the labels.10. Re-attach the plastic covers.4.2.5.3 Graphical front panelThe L30 includes software for labelling the LEDs and pushbuttons on the graphical front panel and a sticker sheet with pre-printed and blank labels. The pre-printed labels are on the top-left of the template sheet, and the blank labels are on thebottom-right. Use the pre-printed labels, or use the designer provided in the software and print the labels onto thetemplate. One sheet is provided.The example shows LED labeling in the top-right portion and pushbutton labeling in the bottom-right portion.To create LED and pushbutton labels for the front panel:1. In the EnerVista software, in the Online or Offline Window area, access Settings > Front Panel Label Designer orFront Panel Label Designer (at the root level). The designer window opens with pre-configured labels.2. Under File > Print Setup, change the page orientation to Landscape.3. In the label designer window, delete all labels not wanted for printing. This can be done by clicking the Reset button toclear all labels, or by selecting each unwanted label and deleting it. Otherwise, all labels displayed print on thetemplate and use up the template. If you make a mistake, exit the window and open it again to view default labels.4. Based on the location on the template on which to print, create the labels by typing in the appropriate slots.
